The SpeedCal install goes exactly like their instructions say except for the actual routing of the wires. The instructions show the install on a stick car - not much help for us AODE guys.

I followed the instructions exactly except where noted below.

First you unwrap a portion of the wire going to the cigaratte lighter. You’ll want to install your scotch lock onto the BLUE wire. You can verify this with a multimeter.

Be sure to wrap your connection with some electrical tape to prevent a short and to relieve any strain on the connection.

To get the SpeedCal harness through to the transmission, unscrew the front two bolts from the shifter. You can see the bolt holes in the picture above.

With the front two shifter bolts unscrewed you can rock the shifter far enough backwards to slide the SpeedCal harness through and continue with the wiring under the car.
The rest of the instructions are straight forward. Plan on about 30 minutes from start to finish.

I pulled all the slack harness into the car after I was done to keep any excess wire from being loose underneath.